Kärcher AP 100/50 M Bedienungsanleitung Seite 17

Getthe electrical components checked and
repaired onlу bу authorised customer se,v-
lсe persons.
Contact an authorised customer seruice
person in case of problems лof mentioned
in this chapter or if уou are in doubt or when
уou have been eхpliсitlу asked fo do so.
Fault Remedy By
whom
Applianсe сannot
be started
Cheсk if the mains plug is сonneсted.
Operator
No or inadequate
suсtion power
Reset fuse of suсtion turbine.
Operator
Еmpty the diгt water reservoir.
Operator
Foam generated in dirt water reservoir? Use Iess or a dif-
ferent detergent. Use defoamer.
Operator
Close the сover of the diгt water reservoir tightly.
Operator
C|ean the sea|s between dirt water reseгvoir and сover
and сheсk for tightness, replaсe if required'
Operator
Cheсk suсtion hose, the suсtion pipe and the floor nozz|e
for b|oсkages; сlean if required.
Operator
Cheсk the сonneсtion between the suсtion hose and the
appIianсe.
Operator
CIean the sieve in the wastewater reservoir. Operator
Cheсk the suсtion hose for tightness; replaсe if required.
Operator
Chесk if the сover on the diгt water disсharge hose is
с|osed
Operator
Clean the floater in the diгt water tank. Operator
no water jet
Cheсk fresh water fi]ter; сlean if required. Operator
Pull on the lever of the hand spray gun until all the air has
emerged from the pump.
Operator
Cheсk the high pressure hose for damages (risk of bursЬ
ing). Please arrange for the immediate exсhange of a
damaged high-pressure hose.
Operator
Water pressure is
too Iow
Cheсk the nozzle size, install сorrect nozz|e
Operator
The pump does
not run
Reset the pump fuse.
Operator
Е N - 8
1 9