Efco Uhlig 43 000 22 Betriebsanleitung Seite 42

C C Information while the program is running
Press 1 x, displays Press 1 x, displays Press 1 x, displays
Press 2 X, displays: Press 2 X, displays:
Press 3 X, displays Press 3 X, displays
Current ramp, St.03
Current program
Press 4 x, displays Press 4 x, displays
Press 5 x ,displays Press 5 x ,displays
If the programmed parameters cannot be achieved (temperature fluctuates too much above or below the
program setting), you can run the self-optimisation program.
Use the UP arrow key to select "on", self-optimisation will start. Self-optimisation is indicated by the RUN
message. The program runs, the controller analyses the kiln's performance and adjusts cycle times for
future use.
Press 6 x Press 6 x
Safety note
Changes in conF menu can lead to failure of the regulator and blow the heating elements of the kiln.
Damage resulting from changes in the conF menu is excluded from the warranty.
SPu the present temperature in the program. SPu the present temperature in the program. SPu the present temperature in the program.
This should match the temperature in the kiln. This should match the temperature in the kiln.
If there are large differences, the
kiln will not reach the
When changing ramps can be skipped.
cHro elapsed time since the program started
in h.min in h.min
= Ramp 3
cY.02 = Program 2
out.P average power of the
kiln % since program start.
tunE on = Self optimisation:
The controller shows the start The controller shows the start
Temperature and adjusted
ramp setting.
program.