Efco Uhlig 43 000 22 Betriebsanleitung Seite 41

03-S = = 3rd ramp temperature
Screenshot shows 800 °C.
Press OK to select .
This ramp will heat the kiln to 800 °C over a minute.
The controller detects that this setting is not possible.
The Run light flashes and Wait is displayed.
The next ramp is started once the temperature reaches 800 °C
and the kiln heats up on maximum power.
Up to 45 different ramps can be entered.
Finish programming by entering 0 as the last ramp time.
04-t = = 4th ramp temperature
Enter 0, the screen displays End.
Press OK to select.
The program menu closes.
b2 Selecting a programmed ramp
The previous program has finished and StoP is displayed.
If a program is running, either leave to complete, or terminate
by pressing the Start/Stop button until StoP is displayed.
Press the Start/Stop button use the arrows to scroll through the
Programs (cY01 to cY15) to select the required firing cycle.
Press OK and the program will start.