Operation - Efco Uhlig 43 000 22 Betriebsanleitung

c) Assemble or disassemble the fixed element of the beads door
c) Hook the wanted door
d) Mount the door angle
It is necessary to assemble the door angle after changing doors to prevent the
door opening while the kiln is in operation
9.

Operation

Operation of the temperature controller
The temperature controller serves to control the heating-up temperature of your kiln.
Introduce the temperature sensor supplied with the controller into the socket provided for the
sensor on the back of the kiln.
After switching on the controller first shows all display segments, then briefly the current software
version and then switches to the operating mode.
In run mode, the controller goes to the last selected program and continues this, if the program
was not completed.
Complete the program or end by pressing the start/stop button until the display stOP is dis
played.
The regulator has two modes of operation:
a.) As a temperature controller (Reach temperature and hold).
b.) operating as a firing cycle controller, it can run 15 programs (CY01 to cY15) with up to 45
Ramps in each program.