Efco Uhlig 43 000 22 Betriebsanleitung Seite 39

RUN light is on to show that the program is running, C1 indicates that
the oven is heating up.
The controller maintains the pre-set temperature until the Start/Stop
button is pressed and the display shows StoP .
If the controller is turned off without having pressed the Start/Stop button,
the program recommences automatically on restart.
If the controller is turned off in StoP mode turned, the temperature
required has to be re-entered.
b. Operating as a controller with ramps
b1 programming the ramps
The previous program has finished and StoP is displayed
If a program is running, either leave to complete, or terminate
by pressing the Start/Stop button until StoP is displayed.
Press the PRGM button and use the arrow keys to scroll to
a program (cY15 to CY01).
Press the OK button to select the program chosen.
Inputting the ramps.
A ramp is a combination of time and a temperature setting.
Use the arrow keys to adjust the entry.
01-t = first ramp time
The screenshot shows two hours
Press OK to set.