Troubleshooting Checklist; Warranty - Terrier TTL Gebrauchsanleitung

10 TROUBLESHOOTER'S CHECKLIST
Trouble/problem
Load slips
Clamp does not hinge
smoothly
Housing bent
Lifting eye is oval-shaped
Bolts are crooked
Check nuts
11

WARRANTY

Terrier Lifting Clamps B.V. provides a 5 year warranty on its lifting clamps. This warranty
is applicable to the original end user of the lifting clamps. Only if the clamp has been
inspected, checked and maintained by this instructions and by an official dealer. This
warranty period of 5 years is valid from the day of purchase, and is liable to all conditions
and measurements stated in this document.
11a CONDITIONS
This warranty only covers failures in the lifting tools which is the consequence of pro-
duction errors which occur during normal use. The warranty covers no wear to compo-
nents such as pivots, pressure feet, cam assemblies, lock springs etc. Should there be any
kind of failure within this guarantee period, the lifting tool will be replaced or repaired
to insight of the producer.
No warranty is given to clamps due to the following failures:
- Regular wear
- Overload.
- Wrong and/or carelessly use.
- Damages.
- Not following procedures and measures.
- Hoisting differing material other than indicated on clamp or stated in the user-manual.
- Adapting and/or modifying of the Terrier clamp.
- The injudicious use of the clamp, and not succeeding all indications which are stated
in the user's manual.
- When maintenance and/or revision has not been carried out by an authorized Terrier
distributor.
The producer is not responsible for incidental damage or damage due to wrong use of the
lifting tools as well as from violation of this manual.
Possible Cause
Load is dirty
Clamp is open and bent
Bolts too tightly fastened
Clamp overloaded
Clamp overloaded
Clamp overloaded
Clamp is overloaded
Incorrect installation
Action
Clean the load
Reject clamp
Loosen the bolts slightly
Reject clamp
Reject clamp
Reject clamp
Reject clamp
Mount new check nuts
13