Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONTENTS
1
2
3
4
5
6
7
8
9
10
11
1
GENERAL
Please carefully read the instructions in this user manual before using the lifting clamp.
If you have any doubts, please consult with your dealer.
Thank you for choosing one of our high-quality products.The quality systems of manage-
ment and services of Terrier Lifting Clamps B.V. fully comply with ISO 9001 standards. The
many years of vast experience are a guarantee of optimum quality and safety. Terrier lifting
clamps are manufactured from high quality alloy steels and comply fully with all standards
and product requirements including: European standard NEN13155, Australian standard:
4991, US standard: ASME B30.20-2010 and machinery directive 2006/42/EG.
2 APPLICATIONS
The Terrier TBLC is equipped with two clamping jaws which are fitted with special plastic
to avoid damaging the lifting object.
The Terrier TBLC clamp is suitable for the vertical lifting and transporting of a wide range
of products with parallel flat sides such as ferrous and non-ferrous metal plates, structures,
aluminium, wood, plastic, concrete and stone, with the exception of rough-cast concrete.
On lifting no damage is caused by the clamp. The clamp is locked in the open position.
By swivelling the lever and moving the lifting eye upwards the clamp closes and is now
ready for lifting. If the lifting object is put down the clamp opens automatically.
When using the Terrier TBLC safety clamp only one (1) object may be transported or lifted.
The safety clamp is provided with a latch, so that when moving without load the clamp
remains in the open position.
To lift the above materials the TBLC safety clamps can be used per item, per set or with
multiple clamps simultaneously. When using two or more clamps it is important that each
clamp is loaded proportionally. In this case we recommend using a spreader beam.
Additional technical documentation is available from the manufacturer.
3 OPERATING INSTRUCTIONS
Place the clamp in the open position on the object, so that the legs of the clamp are fully
on the object. Ensure that the plate surface where the clip is to be placed is completely free
of dirt, grease, oil, corrosion and contamination; then swivel the safety lever. When the
crane starts lifting the clamp will close; support the clamp until it is tight and then continue
lifting. When the load reaches its destination allow the hook to drop down far enough so
that the clamp is not under any load, i.e. the lifting chain is no longer tight and the clamp
9
9
9
10
11
12
12
13
13
13
13/14
9
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
