Maintenance; Disassembly/Assembly - Terrier TBLC Gebrauchsanleitung

6

MAINTENANCE

For optimal safety check the clamp fully at least once per month.
Do not use the clamp if:
- it is cracked or deformed,
- the lifting eye is visibly deformed,
- the spindles are visibly distorted,
- the spring pins are missing,
- the side(s) of the legs at the location of the spacer pins is/are pressed in.
On finding any of the above defects see Section 7 and Section 8.
7

DISASSEMBLY/ASSEMBLY

Disassembly: Important! Note that when disassembling place all the parts in such a way
that when they are mounted they are in the correct position and location.
Place the Terrier TBLC clamp flat on a workbench.
Remove all nuts and bolts from the clamp.
Remove the plastic jaws.
Remove the legs one by one and all spacers.
Assembly: When assembling the clamp carry out the above in reverse order.
Always use new locknuts and if necessary use new bolts and new spring pins.
Tighten all the nuts with a force such that each fixed arm or leg of the clamp can move
without play. If in doubt, consult one of our technicians. After assembly, the clamp should
be tested on a certified test bench with a test load of 1.2 x WLL
12