Britton CountryClassic Gebrauchsanweisung Seite 11

Maintenance and care
• Your stroller has been designed to meet safety standards and with correct use and mainte-
nance will give many years of trouble free performance.
• The chassis is strong but will weaken should the back wheel be bumped down stairs or
kerbs. Continual impact will cause damage.
• If your child wears hard shoes these might damage the soft fabric.
• If the stroller is used near the ocean or salted roads, spray the chassis with a those, and
dry.
• Be careful during transportation and storage as the surface of the chassis is fragile.
Scratches that arise after the sale are not a justifi able complaint.
• Store your stroller in a dry, safe place.
• Storing a damp stroller will encourage mildew to form.
• After exposure to damp conditions, dry off with a soft cloth, open fully and allow to dry
thoroughly before storing.
• Do not leave the stroller in sunlight for prolonged periods - some fabrics may fade.
• Do not leave the stroller under -10°C or over +30°C degrees of temperature for long time
to prevent getting rusted or maturing.
• This stroller requires regular maintenance by the user.
• Britton products are designed to operate with minimum maintenance, however regular
®
lubrication of moving parts will extend the life of your stroller and make opening and folding
easier.
• Should parts of your stroller become stiff or diffi cult to operate, apply a light application of a
spray lubricant e.g. silicone. Do not use oil or grease.
• It is recommended to lubricate the wheel axles and suspension system every three months
(clean axles with a cloth prior to lubrication).
• Regularly clean the chassis and metal parts of the vehicle, dry off and lubricate all joints
of the chassis. Spokes, and fenders on all wheels, should frequently be wiped off with a
dry cloth. When the pram is used during the winter time, cleaning of the pram should be
done at least once a week. Lack of maintenance could cause corrosion on the spokes and
fenders. Should corrosion on the surface occur, which is a possibility, you are required to
remove this with car wax.
• Regularly inspect the locking devices, brakes, wheels, harness assembly, catches, seat
adjusters, joints and fi xtures to ensure they are secure and in full working order.
• They should be free to move at all times.
• Brakes and wheels are subject to wear and should be replaced if necessary.
• The hood may be cleaned by sponging lightly using warm water and a mild detergent.
• Plastic and metal parts may be sponged clean with warm water and a mild detergent.
• Never clean with abrasive, ammonia based, bleach based or spirit type cleaners.
Distributor: Speli Baltic Ltd.; info@brittonbaby.com; +4416 1408 0181
9
EN