6.3 Mounting And Dismounting - Stahl 9170/*0 Betriebsanleitung

Operating Instructions

6.3 Mounting and dismounting

6.3.1 Mounting of pac-Bus
The pac-Bus is an accessory, which facilitates the wiring of the power
supply and the common fault signalization.
The components of the pac-Bus type 9194 need to be ordered separately.

Assemble the required number of pac-Bus
elements.

Snap the pac-Bus segment on the DIN rail.

Assemble the terminal set at the beginning and
the end of the pac-Bus segment.
6.3.2 Mounting / Dismounting on DIN rail with or without pac-Bus
Mounting
Take care that the devices is not canted before it is snapped on the DIN rail.

Put the device on the DIN rail. Take care that the cut out of
the enclosure fits onto the edge of the DIN rail.

Swivel the device until it is snapped on the DIN rail.
Dismounting

Pull the latch (1) with the screw driver out.

Swivel the device out.
18
Switching Repeater Type 9170
english