Tool Specifications; Operating Controls; Noise/Vibration Information - Protool MXP series Bedienungsanleitung

MXP 800/1000 E - GB Seite 8 Montag, 5. Februar 2001 11:51 11

Tool Specifications

Mixer
Power input
No-load speed:
Electronic speed pre-selection
Mains cable module (Plug it)
Tool holder
Stirrer - ø (max.)
Clamping collar dia.
Weight
Protection class

Operating controls

1 Auxiliary handle
2 On/Off switch with speed control
3 Lock-on button
4 Thumbwheel for speed pre-selection
5 Venting slots
6 Tool holder
7 Wrench flats
8 Open-end wrench
9 Stirrer (not included in the standard delivery)
10 Socket (MXP 1000 EQ)
11 Sleeve (MXP 1000 EQ)
12 Mains cable module (MXP 1000 EQ)
Not all of the accessories illustrated or described are
included as standard delivery.

Noise/Vibration Information

Measured values determined according to
EN 50 144.
MXP 800 E
Typically the A-weighted sound pressure level of
the tool is 86 dB (A). The noise level when working
can exceed 99 dB (A). Wear hearing protection!
The typical hand-arm vibration is below 2.5 m/s
MXP 1000 EQ
Typically the A-weighted sound pressure level of
the tool is 88 dB (A). The noise level when working
can exceed 101 dB (A). Wear hearing protection!
The typical hand-arm vibration is below 2.5 m/s
8
MXP 800 E
780 W
340 - 900 rpm
•
—
M 14 x 2
120 mm
43 mm
2.5 kg
II /
Notes on Safety
This machine can only be operated
safely when the operating and safety
instructions are completely read and
strictly observed.
For further notes on safety refer to the enclosed
sheet.
Always check the machine, cable and plug
before using. Have damages repaired only by a
qualified professional.
The machine should not be operated in damp,
wet locations; nor in the open during a rain, fog
and snow, or in environment with a risk of explo-
sion.
Connect machines that are used in the open via a
residual current device (RCD) with an actuating
current of 30 mA maximum. Use only extension
cables that are approved for outdoor use.
Caution with long hair and jewellery. Work only
with close-fitting clothing.
Wear safety glasses (danger of splashing!)
Make sure the machine is switched off before
inserting the plug into a socket.
Always direct power cable to the rear, away from
the machine.
2
.
Always ensure that you have a secure footing
while working.
Secure the vessel with the mixed substance
against moving on the floor.
Do not mix explosive substances (e. g. easily
inflammable solvents) and materials with a com-
2
.
bustion point below 21 °C. Observe the process-
ing instructions of the manufacturer.
GB
MXP 1000 EQ
950 W
260 - 700 rpm
•
•
M 14 x 2
140 mm
57 mm
4.8 kg
II /