Indicators On Display Panel - Inventor R51M/E Benutzerhandbuch

TIMER OFF Button: Press this button to initiate the auto-off time
12
sequence. Each press will increase the auto-timed setting in 30
minutes increments. When the setting time displays 10, each
press will increase the auto-timed setting 60 minutes increments.
To cancel the auto-timed program, simply adjust the auto-off time
to 0.0.
LOCK Button: When you press the recessed LOCK button, all
13
current settings are locked in and the remote controller does not
accept any operation except that of the LOCK. Press again to
cancel the LOCK mode.
TURBO Button: Active/Disable Turbo function. Turbo function
14
enables the unit to reach the preset temperature at cooling or
heating operation in the shortest time(if the indoor unit does not
support this function, there is no corresponding operation
happened when pressing this button.)
CLEAN AIR Button(on some models): When push this button,
15
the Ionizer or Plasma Dust Collector(depending on models) is
energized and will help to remove pollen and impurities from
the air.

Indicators on Display Panel

DIGITAL
DISPLAY area
TRANSMI-
SSION Indicator
OPERATION
MODE Indicator
LOCK Indicator
TIMER
DISPLAY Indicator
DIGITAL DISPLAY area: This area will show the set temperature
1
and, if in the TIMER mode, will show the ON and OFF settings of
the TIMER. If in the FAN mode, nothing is appeared.
TRANSMISSION Indicator: This indicator flashes one time
2
when remote controller transmits signals to the indoor unit.
Display Panel
TIMER ON OFF
Fig. 2
3
ON/OFF Indicator
OPERATION
MODE Indicator
FAN SPEED Indicator