After-Sales Service; Warranty - AKO RD 907 TS Bedienungsanleitung

Setting Programmes
Press the 'PROGRAM' key twice to set the programs.
You are now setting the programs starting with P1 'ON'.
SETTING P1 ON TIME:
1. To set the hour use the '-' & '+' buttons. Confirm the hour digit by pressing
'ENTER'.
2. To set the minutes use the '-' & '+' buttons. Confirm the minute digit by pressing
'ENTER'.
Note: The minutes can only be set in 10 minute blocks in programme 'MODE'.
SETTING P1 OFF TIME:
3. To set the hour use the '-' & '+' buttons. Confirm the hour digit by pressing
'ENTER'.
4. To set the minutes use the '-' & '+' buttons. Confirm the minute digit by pressing
'ENTER'.
Repeat steps 1 to 4 to programme P2, P3 & P4. After programming P4 'OFF' you
automatically exit to the default display.
At any time while programming the timer you can press the 'PROGRAM' button to
exit to the default display.
Note: If the 'ON' time is the same as the 'OFF' time the appliance will ignore the
program.
The Advance Function
When in 'AUTO' MODE, if the '+' button is pressed for longer than 2 seconds the
programme will ADVANCE to the next setting programmed and will only revert
back to the program when the subsequent programme time is reached. When the
'ADVANCE' function is running the 'ADVANCE' segment will be displayed on the
LCD screen. If the '-' button is pressed when the 'ADVANCE' programme is running
the 'ADVANCE' feature will be automatically cancelled and the programme will
run as normal.
Note - Timer Memory Back Up Batteries - Once the heater has been left plugged
in with the socket switched on for at least 72 hours the timer's memory back up
batteries will be fully charged.
Once the timer batteries are fully charged, if there is a power cut or if the heater is
disconnected from the mains for less than six months, then the timer will continue
to keep time & the settings in the memory will remain intact.
If however the timer back up batteries have not been charged fully, or if the heater
is deprived of power for longer than six months, then the time and the programme
settings are likely to be lost and you may therefore need to reset the time and the
programme before using the AUTO MODE again
Cable storage (see Fig. 1)
If the radiator is not required the supply cord should be unplugged and be neatly
coiled around the cable wrap ensuring that the plug does not trail on the floor.
Do not use the appliance with the cord coiled!
Cleaning
· Switch off the appliance first and disconnect the plug from the socket!
· Clean the housing with a moist cloth, vacuum cleaner or brush.
· Do not use any abrasive or caustic cleaning agents!
· Do not use any flammable cleaning agents e.g. petrol or spirit for cleaning the
appliance.
· Never immerse the appliance in water! Danger to life!
· Air inlet- and outlet area should be cleaned with a vacuum cleaner regularly.
· If the appliance is not used for extended periods, it must be protected against
excessive dust and dirt.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be disposed
of with household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice in your country.
After Sales Service
All repairs must be referred to authorised personnel!
See your local dealer.Any tampering with the appliance will invalidate the warranty.
Repairs carried out improperly and by unqualified persons may have serious
consequences for the user!
In the interests of further development, the appliance may be subject to
constructional or design changes without prior notice.

Warranty

The warranty conditions in the country of purchase apply to this appliance.
Information can be obtained at any time from the retailer from whom the appliance
was purchased.
For claims under guarantee the sales receipt must be produced and the claims
must be forwarded within the guarantee period.
The right to claim under guarantee expires in case that the device has been
damaged, used in an inappropriate way or that unauthorized manipulations have
been carried out.
GB