Checking The Battery Condition; Maintenance And Care - Waeco PowerPack 5in1 Bedienungsanleitung

PS-300-IC.qxd 16.11.2005
The charge status is indicated only properly 15 minutes at the earliest after the charging
process has been finished and the charging cord/mains charger has been pulled out or a
consuming unit has beendisconnected.
- Push the button "Test Battery" (see
Depending on the charging level of the battery, up to 4 LEDs light up (see
High = the battery is charged. No charging required.
Mid = the battery is sufficiently charged for actual operation but needs charging after use.
Low = the battery is nearly empty and should be charged.
Empty = the battery is empty. Charge the battery.
The PowerPack is equipped with an undervoltage protection. With low discharging, the
PowerPack switches off automatically. Please charge the PowerStarter immediately to
avoid damage.
The PowerPack is equipped with a maintenance-free 12 V, 18 Ah battery.
Caution! Avoid strong heating-up of the PowerPack, e. g. strong solar
radiation in the vehicle, heating up by the vehicle heating system etc.
With too strong heating up there is the danger of explosion!
Charge the PowerStarter every 3 months when not in use. To clean the PowerPack, use a
soft dry cloth. To remove stubborn dirt, use a cloth which is only slightly dampened with
water. Do not use solvents.
12:28 Uhr Seite 24

Checking the battery condition

C 2).

Maintenance and care

24
C 3):