Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step 1:
1.
Connect the counter weight cable (9) and the counter weight (14), Then put it into weight plate
hanging tube( right) (2)
2.
In sequence,put the sliding sleeve (5), rubber cushion(4), safety hook (right) (3),guide rod lock
sleeve(12) installed on the guide bar (11).
3.
Fix step point 1and 2 with bottom tube(right) (1) and fixed tube(right)(13) together,and choose
corresponding screw group(6.8.10):(7.8.10). The position is as shown in the installation step 1. Elicit
counter weight cable(9) out of fixed tube(right)(13) and pull forward, then roll the frontpulley and
pull vertical through the hole in fixed tube (right) (13), and assembling it on sliding the sleeve (5).
36
Werbung
