Important Notes - Eos Infrasky 3000 Montage- Und Gebrauchsanweisung

Important notes

Risk of fi re if assembled incorrectly.
Please read these assembly instruction
carefully though and retain it for further refe-
rence. Take special note of the advised safety
gaps and the following notes.
• The infrared radiator is designed for 230 V
50 Hz voltage.
• Assembly and connection to the timer unit
must be carried out in accordance with the
connection diagram.
• Before the radiator is switched on, check
that all connections are secured and tighte-
ned properly with no risk of getting loose.
• The EU 60335-2-53 (VDE 0700 Part 53)
regulations shall be complied with.
• Notice that the main energy discharge in
the unit occurs through the infrared radia-
tion.
• Take care to ensure that the IR radiator is
not exposed to any mechanical stresses
(hits, tension, pressure). Risk of damage.
• Although breakage is unlikely when the ra-
diator is used properly, if it is nevertheless
broken or damaged, don't use it anymore.
Replace it with a new one.
Caution: fi re risk in the case of a
broken radiator.
Never look directly at the IR radi-
ator for a longer time, as it may
cause risk of eye damage. Always
wear a special eye protection goggles.
In the case of any skin disease or illness,
make sure to consult a doctor before
use.
This unit is not a medical device designed
for medical purposes in the sense of the
German Medical Products Law (MPG).
This unit shall not be used for medical
purposes.
12
• This device has not been designed
for being used by persons (including
children) that are physically or mental-
ly handicapped or have sensory disabi-
lities. Furthermore, it is not allowed to
use this device without suffi cient expe-
rience and/or knowledge, unless these
persons will be supervised by persons
responsible for their security or in case
they have been instructed how to use
this device.
• Children are not aware of the dan-
gers which may occur when operating
electrical appliances. Children must
therefore never be allowed to operate
electrical appliances without adult su-
pervision.
• Do not use the appliance in bath rooms,
rooms with high humidity or near swim-
ming pools.
• The tanning system must be installed
in a dry room and kept free of exposure
to spray or drop moisture.
• When installing the IR radiation system,
please ensure that the ceiling has suf-
fi cient load-bearing capacity (min. 70
kg). If the capacity is lower, the ceiling
has to be reinforced and the installer
must furnish appropriate documentati-
on.
• Relative air humidity of max. 70% as
well as room temperature from 15 °C to
28°C shall be observed.
• Do not switch on the unit in any area
which may contain explosive vapours.
Repairs to the IR radiator may be carried
out only by a qualifi ed electrician or by plant
customer service personnel.
Always disconnect the system from
the power source when performing
works on the system (servicing or
cleaning operations).
GB