Transport And Storage; Transport Of The Pyrometer; Storage Of The Pyrometer - KLEIBER Pyroskop 840 Betriebsanleitung

11 Transport and Storage

11.1 Transport of the Pyrometer

CAUTION:
Environmental factors, impacts and the formation of water condensation may damage some compo-
nents!
When transporting the pyrometer, take suitable measures to protect all components from environmen-
tal factors, impacts and the formation of water condensation! Temporary storage of the pyrometer in
the open air is not permitted!
Look at Taking out of service (section 13.1) at page 31 how to dismantle the pyrometer.
It is advisable to use the original packaging for the shipping of the pyrometer. If the original packaging is no
longer available, the pyrometer should be shipped in a cardboard box with shock-absorbing PE material.
When transporting the pyrometer observe the following instructions:
• Take great care when transporting the pyrometer to avoid damage through the effect of force, or careless
loading or unloading.
• Avoid jerks, vibrations and the formation of condensed water due to severe temperature deviations while
transporting.
• In the case of overseas shipping, a suitable desiccator (e.g. silica gel) should be inserted and the pyrom-
eter should be sealed together with the desiccator in a protective plastic sheet.
• If the pyrometer is not immediately installed after delivery and put into operation, then it should be care-
fully stored in a location protected against dust and humidity (Storage of the Pyrometer (section 11.2) at
page 29).
The pyrometer is thus ready to be shipped.

11.2 Storage of the Pyrometer

CAUTION:
Environmental factors, impacts and the formation of water condensation may damage some compo-
nents!
Store the pyrometer only in dry areas without large variations in temperature! The atmosphere should
be free of dust and corrosive vapors!
CAUTION:
For pyrometer with direct optics: There is a danger of destruction by using freezing cooling water with
a storage temperature < 0 °C!
Before storage of the pyrometer if applicable remove any remaining cooling water from the cooling
ducts of the equipment! Storage of the pyrometer with coolant remaining in the cooling ducts is not
permitted!
Store the pyrometer appropriately in the original packaging. Put a suitable desiccant inside the packing (e.g.
silica-gel) to prevent damage by moisture. Protect the pyrometer against dust through suitable measures.
The following climatic conditions are required in the storage room of the pyrometer:
• Temperature range -20 °C . . . +70 °C
• Maximum air humidity to 70 %
• Atmosphere free of dust and corrosive vapors
Pyroskop 840
11 Transport and Storage
29