Ecom Ex-PMR 1000 Bedienungsanleitung Seite 27

16 channel storage spaces
So you always have sufficient fixed alternatives for your radio partners.
CTCSS & DCS
With CTCSS/DCS, you can ignore unwanted calls from other parties on the same
channel. When CTCSS/DCS is set, the user can only receive the calls on the same channel
with the same CTCSS/DCS.
Please observe: Although you can ignore unwanted calls with CTCSS/DCS, this does not
mean that your conversations are private.
TOT Switch-off Timer
The Time-out function is used so as not to use the same channel too long and to prevent
damage to the device due to continuous transmission.
If the transmission exceeds the prescribed time (60 s), it is interrupted and an alarm sounds.
This is stopped by releasing PTT. Press PTT again to transmit.
TOT-Reset Time
If the send pause is longer than the set time (TOT-Reset Time), the TOT – shut-off timer will
be reset. If the send pause is shorter than the set time (TOT-Reset Time), the TOT – shut-off
timer will be added on.
The function is deactivated. Changing the setting is only possible with optional software.
TOT – Rekey Time
After activating the TOT – shut-off timer, the send function is blocked until the pre-set time
(TOT-Rekey Time) has lapsed.
The function is deactivated. Changing the setting is only possible with optional software.
TOT – Alert Time
An alarm sounds at a programmed point in time before activating the TOT – shut-off timer.
Subsequent send interruption by TOT – shut-off timer.
The function is deactivated. Changing the setting is only possible with optional software.
Monitor
Radio activities on the current channel can be monitored by pressing and holding the
"MONI" key. This is especially useful for setting the volume or if you are receiving a weak
signal.
When holding the "MONI" key, the green LED display illuminates.
Channel search run
Set the channel switch to "S"; the radio unit then only automatically records the channels
that have been programmed for search run in channels 1-15. If a signal is detected on a
channel, the radio unit stops on this active transmission channel.
26