Sony BVF-C10W Bedienungsanleitung Seite 20

Location and Function of Parts
1 Plug
Connect to the VF connector on the camcorder.
2 Stopper
Prevents the viewfinder from coming off the
camcorder when it is slid from side to side.
3 Tally indicator (rear)
Lights up when the camcorder receives a tally control
signal. This indicator can be covered when not in use.
4 Adjuster for the zebra pattern level range
Insert a precision screwdriver or similar tool, and
adjust the level for which the zebra pattern is
displayed.
5 Diopter adjustment ring
Allows for optimal adjustment of focus.
6 Tally indicator (front)
Lights up when the camcorder receives a tally control
signal. Turn the TALLY switch !¡ OFF when not in
use. The brightness can also be adjusted with the
TALLY switch !¡.
7 PEAKING control
Turning this control clockwise adjusts the picture
sharpness, and makes focusing easier. This control has
no effect on the output signals of the camcorder.
4(E)
8 CHROMA control
Adjusts the chroma level of the screen. This control
has no effect on the output signals of the camcorder.
9 CONTRAST control
Adjusts the contrast of the screen. This control has no
effect on the output signals of the camcorder.
0 BRIGHT control
Adjusts the brightness of the screen. This control has
no effect on the output signals of the camcorder.
!¡ TALLY switch
Controls the tally indicator 6 located on the front of
the viewfinder.
HIGH: The tally indicator brightness is set to high.
OFF: The tally indicator is disabled.
LOW: The tally indicator brightness is set to low.
!™ ZEBRA (zebra pattern) switch
Controls the zebra pattern display on the viewfinder
screen as follows:
ON: A zebra pattern appears and stays.
OFF: The zebra pattern disappears.
MOMENT: A zebra pattern appears and stays for
about five seconds.
!£ DISPLAY switch
Enables or disables the audio level indication when
using the DVW-700 series camcorder.