Before First Use; Initial Use; Connecting The Product To An External Amplifier; Connecting The Product To Electricity Supply - Silvercrest 288644 Bedienungs- Und Sicherheitshinweise

˜ Before first use
The following transportation locks are
attached to the product:
Transport safety lock
¾ ¾
turntable .
12
Head-shell for pick-up system
9
¾ ¾
Remove all packaging material and all
¾ ¾
transport locks from the product .
Unlocking turntable transport lock
¾ ¾
of the turntable
safety lock in clockwise direction until a
2
light resistance can be felt . Then the transport
security is unlocked .
Remove the head-shell
¾ ¾
system .
8
Transport safety lock
¾ ¾
must be installed on the product prior to longer
transports .
˜ Initial use
˜ Connecting the product to an
external amplifier
Plug the cinch cable
¾ ¾
output . Ensure that every jack is plugged
21
in according to the correct colour (red and
white) .
10 GB
for securing the
2
.
8
: Turn the transport
12
from the pick-up
9
and head-shell
2 9
into the Line Out
22
Plug the other end of the cinch cable
¾ ¾
the Line In socket of your amplifier . Music that
is played using the product will now be played
through the external amplifier in addition to
through the built in speaker
ATTENTION
Do not use the phono connector of your
¾ ¾
amplifier to connect the record player . This
might cause damage to your amplifier and
record player .
˜ Connecting the product to
electricity supply
When connecting the product to the electricity
supply, please consider the following tips to ensure
that the product works safely and correctly:
Before you connect the product, compare the
¾ ¾
connection data (voltage and frequency) on
the type plate of the power supply
(model: YeS12W-0900100VS) with that of
your electricity network . These data must
correspond, otherwise damage may be caused
to the product .
Make sure that the connection cable is
¾ ¾
undamaged and does not pass over hot
surfaces and / or sharp edges .
Make sure that the connection cable is not taut
¾ ¾
to avoid tripping hazards .
Connect the barrel jack of the power supply
¾ ¾
with the to the DC input jack
Plug power supply into a well-reachable power
¾ ¾
outlet .
˜ Turning the product on and off
Turn the record player
¾ ¾
button .
16
Adjust the volume using the volume control
¾ ¾
To raise the volume, turn the volume control
clockwise . To lower the volume, turn the volume
control anti-clockwise .
10
into
22
.
13
.
17
on using the POWER
14
.
10
10