Installing The Grille - Mitsubishi Electric PLFY-P20VFM-E1 Installationshandbuch

5. Installing the grille

1
2
When equipped with the signal receiver
4 6
When equipped with the wireless remote controller
8 9
Fig. 5-1
Fig. 5-2
B
A
1
1
C
C
B
<Grille hook>
Fig. 5-5
3
When equipped with the i-See sensor
5 7
0 1
D
D
2
E
A
1
<Grille is hung temporarily>
Main unit
hook
5.1. Check the grille accessories (Fig. 5-1)
Accessory name
1 Grille
2 Screw with washer
3 Gauge
4 Junction wire for signal receiver
5
Junction wire for i-See sensor
6 Fastener
7 Fastener
8
Wireless remote controller
9 Remote controller holder
0 LR6 AA batteries
1
5.2. Preparing to attach the grille (Fig. 5-2)
relative to the ceiling. If the unit is not properly positioned in the ceiling, there may
rectly.
to adhere to this range.
A
Main unit
B
Ceiling
C
Gauge (Accessory)
D
Ceiling opening dimensions
* Do not unlatch the hook for the intake grille.
from the grille as indicated by the arrow
A
Intake grille
B
Grille
C
Intake grille levers
1
indicated by the arrow to remove the corner panel.
A
Grille
B
Corner panel
C
Screw
grille.
Align the screw holes in the corners of the grille with the screw mounting holes in the
corners of the main unit, latch the two hooks on the grille onto the drain pan projec-
tions on the main unit, and temporarily hang the grille. (Fig. 5-5, 5-6)
Caution:
When installing the i-See sensor and signal receiver, place the junction wires
Q'ty Remark
1
4
1
Included when equipped with the
1
signal receiver.
Included when equipped with the
1
i-See sensor.
Included when equipped with the
2
signal receiver.
Included when equipped with the
2
i-See sensor.
Included when equipped with the
1
wireless remote controller.
Included when equipped with the
1
wireless remote controller.
Included when equipped with the
2
wireless remote controller.
Included when equipped with the
2
wireless remote controller.
1
to open the intake grille.
2
.
D
Grille hook
E
Hole for the grille's hook
-