tefen MixRite Bedienungsanleitung Seite 7

TEFEN
MixRite Installation
MixRite direkt an die Wasserleitung anschließen (in Linie)
Ventil Rückschlag-
ventil
Filter
Druck-
begrenzungs-
ventil
Die Abbildung zeigt die Montage der Dosierpumpe direkt an die Wasserleitung
(in Linie)
MixRite an eine Bypass-Leitung installieren (Abzweigung von der
Hauptleitung)
58
Manometer Vakuum- Ventil
ventil
MixRite an
TEFEN
In models 2510, 12510 there is no U-
latch and the adjustment is done by
turning the adjustment sleeve to the
desired %.
In models 2500, 2501,12500, 12501,
there is no possibility to adjust the
dosing percentage, it is predeterment by
the injector model (see page 3).
To decrease
DO NOT REMOVE THE LOWER U-LATCH !!!
(For maintenance purpose only)
Rinsing and Cleaning the unit
After pumping
• Rinse the unit by pumping clean water from the additives
container.
• Wash the external surface of the unit with clean water.
Warning: During pumping, ensure that the additive
container is not completely empty.
Air-release Valve
In models: 2500, 2501, 2502, 2504,2510, 2512, 2514,
After initial operation of the MixRite, apply pressure to the cap (the
air release valve) for several seconds to open valve that allows
trapped air to escape. This air release is accompanied by a slight
loss of water. Release the pressure on the cap to close the valve.
Press to release air
Air is released with a
small amount of
water
7
U-latch
To increase
2512IN, 2514IN.