LaCie 2big Dock Thunderbolt 3 Schnellinstallationsanleitung Seite 6

Configure volume(s)
4
Mac: Your LaCie device comes factory formatted in HFS+ (Mac) format.
The dual disks in your LaCie device have been configured to optimize
performance (RAID 0 mode), but you can instead configure them for data
Mac
protection (RAID 1 mode). Use the LaCie RAID Manager software to set the
RAID mode for your device.
Windows: Your LaCie device comes factory formatted in HFS+, which is a
Mac format. You must use LaCie RAID Manager software to delete the current
RAID volume and create a new volume before formatting the drive. Once
Windows
you've created the new volume, please see the partitioning and formatting
section of your user manual: www.lacie.com/2big-dock-guide.
The 2big Dock Thunderbolt 3 is compatible with Windows PC. If you choose to
connect your device using the Thunderbolt 3 port, the computer needs to meet
the following requirements:
• Operating System: Windows 10 or higher
• Windows PC that supports Thunderbolt 3
Note: Make sure to use the Thunderbolt 3 cable included with your device.
If the 2big Dock doesn't mount or is not detected on your computer when
connecting the drive with Thunderbolt 3, please go to www.lacie.com/
support/2bigDockTBT3 and download and install the 2big Dock
Thunderbolt 3 Driver for Windows.
If you're still experiencing connectivity issues between your device and your
Windows PC, check with the computer manufacturer for updates to BIOS,
Thunderbolt 3 firmware, or Thunderbolt 3 drivers. For additional information,
see your user manual: www.lacie.com/2big-dock-guide.
To learn more about RAID levels and how to use LaCie RAID Manager, see
www.lacie.com/lrm-guide.