Specifi Ca Ons; Charging The Ba Ery - Gallagher TWR-5 Kurzanleitung

SPECIFICATIONS
Opera ng Temperature
Environmental Protec on Ra ng
Input Voltage
Es mated ba ery run me
CHARGING THE BATTERY
To ensure op mum performance of the TWR- , the internal ba ery may need to
be charged for up to 16 hours before fi rst me use.
Important: If the TWR- is to be stored for an extended period, this should be
in a cool dry place with a fully charged ba ery.
1. Connect the power adapter at the base of the unit and plug the TWR- into a
power outlet and switch ON.
The charging icon will display on the screen.
2. When the charge shows 100% the TWR- is ready to use with or without the
power adapter.
Note:
• When the TWR- is in use, the ba ery icon
will display and show remaining charge.
• When using the scale and the charge
level falls below 10% the ba ery icon
will fl ash with a red outline. You will have
about 30 minutes to complete the weighing
session before the TWR- must be charged.
• When the charge level becomes cri cal the unit will shut down.
• To check remaining run me at current se ngs, from the Home screen, go to
Se ngs
2
Gallagher TWR- Weigh Scale Quick Start Guide
> About > Ba ery
o o
-20 to 50 C
o o
-5 to 120 F
IP67
12 V DC
16 hours at 60% brightness
12 hours at 100% brightness
.