Specifications - Makita BSS500 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Lever
3-1. Lever
4-1. Base
4-2. Cutting line
5-1. Lock-off lever
5-2. Switch trigger

SPECIFICATIONS

Max. Cutting depth
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
For Model BSS500
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : cutting chipboard
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
6-1. Shaft lock
7-1. Hex wrench
8-1. Hex bolt
8-2. Outer flange
8-3. Saw blade
8-4. Inner flange
9-1. Hex wrench
10-1. Dust nozzle
10-2. Screw
Model
Blade diameter
at 90°
at 45°
-1
)
Overall length
Net weight
Rated voltage
) : 91 dB(A)
pA
) : 102 dB(A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
BSS500
359 mm
2.6 kg
D.C. 14.4V
ENE028-1
For Model BSS501
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
ENG102-3
Vibration
The vibration
determined according to EN60745:
Work mode : cutting chipboard
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG214-2
The declared vibration emission value has been
•
sum) measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
4
11-1. Dust nozzle
11-2. Hose
11-3. Vacuum cleaner
14-1. Adjusting screw for 90 ﾟ
15-1. Triangular rule
16-1. Limit mark
17-1. Brush holder cap
17-2. Screwdriver
BSS501
136 mm
51 mm
35 mm
3,600
364 mm
2.7 kg
D.C. 18V
) : 92 dB(A)
pA
) : 103 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s or less
h
2
ENG102-3
ENG214-2
vector sum)
ENG901-1