ASROCK K7NF2-RAID Handbuch Seite 11

2.5 Connectors 2.5 Connectors 2.5 Connectors 2.5 Connectors 2.5 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors. Placing jumper caps over the connectors will
cause permanent damage of the motherboard!
FDD Connector
(33-pin FLOPPY1)
(see p.2 item 18)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.2 item 11)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device
vendor for the details. Besides, to optimize compatibility and performance,
please connect your hard disk drive to the primary IDE connector (IDE1,
blue) and CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATA Connectors
(SATA1: see p.2 item 9)
(SATA2: see p.2 item 8)
Serial ATA (SATA)
Data Cable
ASRock K7NF2-RAID Motherboard
the red-striped side to Pin1
Secondary IDE Connector (Black)
(39-pin IDE2, see p.2 item 12)
connect the black end
to the IDE devices
These two Serial ATA (SATA)
connectors support SATA data
SATA2
cables for internal storage
devices. The current SATA
interface allows up to 1.5 Gb/s
SATA1
data transfer rate.
Either end of the SATA data cable
can be connected to the SATA
hard disk or the SATA
connector on the motherboard.
1 1 1 1 1 1 1 1 1 1