Exodraft RSVG series Anleitung Seite 5

3000127 RSVG DK DE NO SE UK NL FR 120515
Step
3 Adjust the distance between the location brackets to fit
the inside diameter of the chimney, and then tighten
the nuts. Note that there should be a 2-4 mm gap
between the brackets and the chimney so as to avoid
transmitting vibrations from the fan to the chimney
A and B measurements: please refer to step 1.
Before fitting onto a steel chimney
Step
1 A flange (D), supplied as extra, is used, fitted so that the
spigot end sits inside the chimney (E).
2 Place the mineral wool mat (B) on the flange (D) with
aluminium foil facing upwards and cut a hole in the
mineral wool mat, the hole being the same diameter as
the flange hole.
3 Cut the corners of the mineral wool mat, so there is
room to fit the vibration dampers (C).
4 Fit the flange to the chimney fan, with the use of the
vibration dampers.
5 The fan can now be fitted onto the chimney..
Action
Action
A
B
C
D
E
UK • 5