Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10
Adjustments
• No adjustment is necessary. This is carried out in
our workshops.
11
Maintenance
(the motor must be stopped)
Before carrying out any operation
disconnect the machine from the
mains
• Clean the machine daily.
• Empty regularly the tank to remove muddy depo-
sits which could clog the pump and thus cause
premature wear.
• Wash the tray with plenty of water.
• Clean the pump.
• Store in a dry place
• Clean the rails with particular attention.
Store in a dry place, not accessible to
children.
Maintain the tools carefully.
FAULT FINDING
In the event of faulty operation refer to the tables
below to find a solution.
• The machine does not work
CAUSES
Not plugged in proper-
ly or cable damaged
No mains voltage
Switch
defective,
motor cable damaged
Motor
faulty
(no
power,
unpleasant
smell)
• Difficult starting
CAUSES
Single phase motor
starting condenser
• The pump does not start
CAUSES
The mains lead is not
correctly connected or
is damaged
No voltage in pump
circuit or mains supply
circuit
• The pump does not pump water
CAUSES
An air bubble may have
formed inside the pump
body
The turbine is jammed
REMEDIES
- Make sure that the
supply is correctly
plugged
in
(plug,
extension lead, etc)
- Check the supply
cable
- Test or have tested
by an electrician (cir-
cuit breaker, plug,
etc)
- Have tested by an
electrician or contact
the service depart-
ment
- Contact the service
department to have
the motor replaced
REMEDIES
- Replace the conden-
ser
REMEDIES
- Check
the
mains
lead
- Check the pump cir-
cuit and mains sup-
ply circuit
REMEDIES
- Holding the pump of
the outlet pipe remove
it from the water and
reimmerse it
- Unscrew the filter
and, using a small
screwdriver, remove
all dirt from the ope-
rating area of the tur-
bine.
23
Werbung
Inhaltsverzeichnis
