Petra electric MK 12.07 Bedienungsanleitung Seite 17

has stopped completely. Use a spatula. Do not use your fingers.
• Stop the mixer by returning the speed control button to the off
position. Unplug it from the mains electrical supply before you change
the accessories, or before you take the appliance.
• Press the arm release button at the same time lift the swivel arm by
hand until it locks into place.
• Detach the accessory by turning it clockwise.
• Remove the mixing bowl by turning it anti-clockwise.
MEAT GRINDER FUNCTION
• Place the appliance on a flat surface, e.g. a kitchen counter, and make
sure it is standing firmly.
• Remove the protective cover for the meat grinder.
• Ensure that the protective cover for blender is fitted in place.
Safety
• Always remove bone, gristle, tendons, and rind before grinding the
meat.
• Frozen food must be thoroughly defrosted before grinding.
• Never run the meat grinder continuously for more than 10 minutes.
Running the meat grinder continuously for too long without a break
may reduce the life span of the appliance. After having used the
appliance for 10 minutes, take a break and wait at least 30 minutes
before using it again.
Fit the grinder body
• Fit the meat grinder body in the accessory socket, so that the arrow is
aligned with the circle. Turn it to the vertical position, so the arrow is
aligned with the arrow.
• Fit the meat tray onto the meat grinder body so that the wide part is
positioned over the motor house of the appliance. Place a container
under the meat grinder body opening.
• Connect the mixer to the power supply. The display will light up and
beep.
• Turn the speed control button to the desired and recommended speed
setting, time and capacity shown in the table above.
• The timer will count up in 1 second intervals. The speed can be
changed at any time while the mixer is operating.
• Cut your meat into smaller pieces, so the pieces fit into the feeding
tube. Dice or cut into strips with a width of approx. 2.5 cm.
• Put the pieces onto the tray. The meat pieces will go down in the
feeding tube. Push down carefully with the tamper. Do not press too
hard, otherwise you may damage the appliance.
EN
17