Petra electric MK 12.07 Bedienungsanleitung Seite 16

Instruction manual
PULSE BUTTON
• The pulse button can only be used when the speed control button is in
the off position.
• Press the pulse button and the mixer will run at maximum speed for as
long as the button is held in this position. If the bowl content is above
60°C, the speed is automatically limited.
MIXER FUNCTION
Important
• Do not operate the appliance for more than 10 min. continuously
when the dough hook, flat beater, or whisk are working. Running the
appliance continuously for too long without a break may reduce the
life span of the appliance. After 10 min. of working allow the appliance
to cool down for at least 40-45 minutes.
• If the swivel arm will be raised during operation, the mixer will
automatically stop and it will not re-start when the swivel arm will be
lowered. To re-start the mixer turn the speed control button to the off
"0" position and then re-select a speed.
• After 10 minutes of no interaction the display will turn in sleep modus.
If any button or control knob will be touched, the display will resume.
Installing and use
• Place the appliance on a flat surface, e.g. a kitchen counter, and make
sure it is standing firmly.
• Ensure that the protective cover for the meat grinder and blender are
fitted in place.
16
• Press the arm release button at the same time lift the swivel arm by
hand until it locks into place, the swivel arm is now in the upwards
position.
• Fit the lid onto the swivel arm, so that it locks into position securely.
• Place the food in the mixing bowl, fit the tabs on the mixing bowl in
the recess on the motor house. Turn the mixing bowl slightly clockwise,
so it locks into position.
• Place the splash guard onto the kneading hook as shown in the
picture. Turn and fix the hook. The splash guard prevents the dough
from rising above the top of the hook.
• Fit the required accessory onto the motor spindle on the underside of
the swivel arm.
• Place the accessory so that the tabs on the spindle are aligned with the
recesses on the accessory, press the accessory against the swivel arm
and turn it anti-clockwise at the same time until the accessory locks
into position securely.
• Press the arm release button and press down the swivel arm by hand
until it locks into place with a click. The lid must fit tightly with the
mixing bowl, otherwise it is fitted incorrectly. The appliance is now
ready for use.
• Connect the mixer to the power supply. The display will light up and
beep.
• Turn the speed control button to the desired and recommended speed
setting, time and capacity shown in the table above.
• The timer will count up in 1 second intervals. The speed can be
changed at any time while the mixer is operating.
• If you need to scrape the inside of the bowl, wait until the accessory