Remington REVEAL MD3000 Bedienungsanleitung Seite 7

C FITTING AND REPLACING FILTERS
The Microdermabrasion treatment process removes dead skin cells from the outer surface of your skin.
The device is equipped with disposable filters that collect the skin particles during treatment.
• For your convenience the device is fitted with a filter for your first treatment and replacement filters are
included in the pack.
• For optimum hygiene and product effectiveness, it is important to replace the filter after every use and
to place a new and unused filter into the device before each treatment.
, NOTE: Be certain there is always a fresh filter in the device while in use. Use of the device without a filter
would draw the skin particles into the pump mechanism and shorten the life of the device and
invalidate the warranty.
, TO REPLACE THE FILTER:
• Remove the Tip from the Handle.
• Using your fingertip, remove the circular black filter from the end of the suction tube and discard.
• Place a new filter into the suction tube and gently press it into place with your fingertip. Fig. 4.
4
C CHANGING THE DIAMOND TIPS
The tips are clear wrapped for cleanliness and this needs to be removed prior to first use. They attach onto
the device magnetically and must be fully engaged to provide the best suction performance.
, Removing or Changing the Diamond Tips
• Hold the Microdermabrasion Device with one hand
• With the other hand, gently pull the Diamond Tip upwards until it comes off. Fig 5.
• To replace, gently position the Diamond Tip and the magnetic force will pull it into place. Fig 6.
5
C CLEANING AND MAINTENANCE
, NOTE: The handle of the Microdermabrasion Device is not waterproof. Do not submerge the handle or
hold it under running water to clean.
• To ensure long lasting performance and cleanliness of your Microdermabrasion device, clean the
diamond tips and handle after each use.
• Ensure the Microdermabrasion Device is switched off before cleaning.
• Remove the diamond tip and brush away excess skin cells with the cleaning brush provided. When
removed, the tips can be rinsed under running water to clean. Allow to air dry.
, NOTE: The Diamond Tips may accumulate skin cells over time, reducing their effectiveness. If this
happens, then the Diamond Tips can be periodically cleaned using water enhanced with an alcohol
based barber's cleaning solution.
6
ENGLISH
7