Remington REVEAL MD3000 Bedienungsanleitung Seite 5

8 The LED lights will begin to light sequentially to indicate the Microdermabrasion Device is charging.
9 When the Microdermabrasion Device is charged, all the LED lights will remain solid for a minute and
then will go off to indicate a full charge. A full charge will take 4 hours.
10 One full charge will provide up to 90 minutes of cordless usage time depending on the speed setting
selected.
, NOTE: If the battery charge is low, all four LED lights will flash in unison to indicate the device needs to
be recharged.
, QUICK CHARGE FUNCTION:
• The Microdermabrasion Device is also equipped with a quick charge function.
• To utilise this function, charge the Microdermabrasion Device for 5 minutes.
• This will provide approximately 1 or 2 uses.
F INSTRUCTIONS FOR USE
The device is suitable for dry use only. Do not use in the shower or bath.
, NOTE: Depending on your skin type, as the Microdermabrasion process utilises diamond tips
coupled with vacuum suction, you may experience some reddening or increased sensitivity after
your treatment. This is considered perfectly normal and usually diminishes within a few hours.
, TIP: As reddening can occur after treatment, it is recommended to carry out the treatments at the end
of the day.
• It is therefore strongly recommended that you perform a patch trial on the inside of your forearm to
feel how the device works and to see the reaction of the skin.
, TIP: It is also advised to carry out this first trial treatment with the Sensitive Diamond Tip using the
lowest setting.
• Once familiar with the Device and its effect on your skin, you can personalise your treatment by
adjusting the settings and selecting the appropriate tip.
• In use you will feel the Diamond Tip against your skin and a gentle suction sensation from the vacuum
setting.
• Adverse reactions are rare, but if skin becomes unduly inflamed or irritated, stop using the device
immediately.
F HOW TO USE
1 Remove all packaging from the device.
2 For your convenience, the device is fitted with a filter for your first treatment.
, TIP: It is recommended that you always check that there is a filter in place before you commence
treatment.
3 Select your chosen diamond tip to begin your treatment routine.
, NOTE: The tips are clear wrapped for cleanliness and need to be removed before use. They attach onto
the device magnetically and must be fully engaged to provide the best suction performance.
4 Wash and towel dry your face before use.
5 Pull your hair back from your face and secure with a head band or pony tail.
6 Turn the device on by pressing the power switch.
7 Select the desired suction level:
• The Microdermabrasion Device will automatically start on the lowest suction level.
• The suction levels are adjusted by repeated presses of the power switch.
• The LED lights will light up to indicate what suction level the device is on. One LED light indicates the
lowest setting. Four LED lights indicate the highest setting.
8 Press and hold the switch again when you want to turn the device off.
ENGLISH
5