Seg VC 334 Bedienungsanleitung Seite 26

• Do not connect the device with the power supply before you
have not completely removed all packaging components and
transport locks.
• Operate the device only with 220-240V ~/50–60 Hz AC voltage.
All power supply cables that are damaged must be replaced
by a qualified specialist (electrical engineer). Do not use power
strips, multiple sockets or extension cords to connect the
device to the power supply.
• You need a power socket that is properly grounded and
exclusively assigned to the device. Failure to do so may result
in dangerous accidents or damage of equipment.
• The mains plug and the earthed socket must always be easily
accessible after the device has been installed.
• Make sure that the power cable is not damaged by being under
the floor nozzle or when moving the floor nozzle.
• The technical data of your electrical supply must correspond to
the values stated on the rating plate.
• Your house circuit must be equipped with a circuit breaker for
emergency shutdown of the device.
• Do not undertake any changes to the device.
• Before all maintenance and cleaning work disconnect the
device from the power supply. RISK OF ELECTRICAL SHOCK!
• To disconnect the device completely from the power supply,
the power cord must be unplugged from the socket. Never pull
the power cord if you want to pull the plug out of the socket,
always grasp the plug. Do not carry the device by the power cord.
26