Maintenance; Recommended Maintenance Schedule; Flywheel Opening And Cleaning; Warranty Information - Concept2 BikeERG Zusammenbau, Austellung, Pflege, Wartung Und Bedienungsanleitung

ENGLISH

MAINTENANCE

Recommended Maintenance Schedule

After first five hours of use
• Check all fasteners for tightness.
Daily
• Clean saddle, handlebars, step pad and flywheel
cover with a cloth and cleaner after use.
• Do not use bleach or coarse abrasives.
Every 250 hours of use
• Check that the crank arms are tight on the crank axle.
Tighten the clamp screw if needed using the L-key
supplied with the BikeErg. See illustration.
• Check all fasteners for tightness.
• Check for dust inside flywheel with a flashlight.
Vacuum if needed. See illustrations at right.
Verify calibration after cleaning. On the PM go to
Main Menu > More Options > Utilities > Calibration.
As Needed
Check the fit of the seat post. The seat post should move
up and down with only light pressure applied. The seat
post can be adjusted using a ½" wrench (not included)
where shown below. Do not overtighten.

Warranty Information

Concept2 BikeErgs are backed by a limited 2 year and 5 year warranty. For complete warranty information in the US and
Canada, visit concept2.com/warranty.
For warranty information outside the US and Canada, contact the authorized Concept2 dealer in your territory. A list of
authorized Concept2 dealers can be found at concept2.com/international. If you do not find a local dealer in your territory visit
concept2.com or email info@concept2.com.
6
The safety level of the machine can be
WARNING!
maintained only if it is examined regularly for damage and wear.
Replace defective components immediately to ensure safety and
performance or keep machine out of use until repair.

Flywheel Opening and Cleaning

1.
Loosen screws.
3.
5.
7.
2.
4.
6.