Intended Use; Special Safety Instructions - Ayce IC2100AG Originalbetriebsanleitung

INTENDED USE

This machine is intended for grinding and cutting metal with suitable accessories

SPECIAL SAFETY INSTRUCTIONS

Safety Warnings Common for Grinding, Sanding, Wire Brushing, Polishing or Abrasive
Cutting-Off Operations
a) This power tool is intended to function as a grinder. Read all safety
warnings, instructions, illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below may result in electric
shock, fire and/or serious injury.
b) Operations such as sanding, wire brushing, polishing or cutting-off are not
recommended to be performed with this power tool. Operations for which
the power tool was not designed may create a hazard and cause personal
injury.
c) Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe operation.
d) The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool. Accessories running faster than their rated
speed can break and fly apart.
e) The outside diameter and the thickness of your accessory must be within the
capacity rating of your power tool. Incorrectly sized accessories cannot be
adequately guarded or controlled.
f) The arbor size of wheels, flanges or any other accessory must properly fit
the spindle of the power tool. Accessories with arbor holes that do not match
the mounting hardware of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks. If power tool or accessory
is dropped, inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and bystanders
away from the plane of the rotating accessory and run the power tool at
maximum no-load speed for one minute. Damaged accessories will normally
break apart during this test time.
h) Wear personal protective equipment. Depending on application, uses face
shield, safety goggles or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping small
abrasive or work-piece fragments. The eye protection must be capable of
stopping flying debris generated by various operations. The eye protection
must be capable of stopping flying debris generated by various operations.
The dust mask or respirator must be capable of filtrating particles generated
72 | 73 GB