Ayce IC2100AG Originalbetriebsanleitung Seite 83

b. Changing the cutting disc (Fig. 2)
CAUTION : Always ensure that the tool is switched off and unplugged from the power
supply before making any adjustments, carrying out maintenance or changing a disc.
1. Turn the angle grinder on to its back, press the spindle lock button and rotate
the spindle until it locks.
2. Insert the pins wrench into the holes in the outer flange and remove it and the
old disc. Do not remove the inner flange
! Do not use a disc marked with a lower RPM than that of the Max rated
speed shown on the rating plate.
WARNING
Fig. 2
3. Clean the flanges and check the new
disc.
4. Holding the angle grinder with the
spindle facing upwards, check that
the inner flange is on the spindle and
correctly located.
5. Place the disc onto the spindle with
the label facing the angle grinder.
6. Screw on the outer flange with the
protruding spigot section facing
away from the disc. (For grinding
disc, the protruding spigot section
should face the disc).
7. Hand tightens the outer flange until
the disc is secure.
8. Press the spindle lock button and
tighten the flange with the wrench.
9. Turn the new disc by hand, ensuring
that it is tightly secured and that it
rotates fully and does not wobble
unduly.
10. Run the angle grinder under no load
for at least one minute to ensure the
new disc is in good condition. Make
sure you are wearing all the safety
gear and that you face the grinder
away from you.
82 | 83 GB