Kenwood NX-220 Bedienungsanleitung Seite 24

RECEIVING
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls.
This will prevent you from listening to unwanted calls. Refer to
"SIGNALING" on page 25 for details.
■ Receiving Group Calls (Digital)
When you receive a group call on a Conventional channel
and the received group ID matches the ID set up on your
transceiver, you can hear the caller's voice.
When you receive a group call on a Trunking channel, the
transceiver automatically switches to the communications
channel to receive the call.
■ Receiving Individual Calls (Digital)
When you receive an individual call, a ringing tone will
sound and the caller's ID will appear on the display (types I
and II only). To respond to the call, press and hold the PTT
switch and speak into the transceiver as you would during a
normal transmission.
14