The Safety Key - Skandika Fitness HOME RUN SF-1500 Aufbau- Und Bedienungsanleitung

Repeat the above procedure until the walking belt is centered. It may be necessary to test walking belt
tension once you have completed the above procedure if the belt feels like it's slipping while walking.
Refer to the below "Walking Belt Slipping" instructions.
WALKING BELT SLIPPING: If the running belt slips when used

The safety key

ASSEMBLY INSTRUCTIONS
1. First remove and unplug the power cord. Using
the Allen Wrench, turn both left and right rear rol-
ler adjustment bolts clockwise, usually a 1/4 turn.
NOTE: NEVER TURN the bolts more then 1/4 turn at a
time and always keep the running belt centered.
2. Test the
NOTE: Overtightening the belt can damage the tread-
mill.
3. Plug in the power cord, insert the key and walk on the tre-
admill at low speed (around 2 kph/1mph) to determine if
Fig.12
the belt is still slipping. If the belt is still slipping, repeat the
above procedure until the walking belt has been tightened
properly.
The safety key(36) immediately disconnects the power
supply in case of an emergency, e.g. when you fall. In
order to function properly, one end of the key should be
inserted into the device (position A as per illustration on
left side) and the other end (clip end) should be attached
to your clothing (e.g. on the waistband).
In case of an emergeny, just pull on the rope, which will
disconnect the key from the device and the device will
stop immediately.
The running belt only starts moving, if the safety key has
been inserted into the device properly.
Please keep the safety key securely after your workout
Fig.13 Fig.13
and out of reach of children!
tightness of the belt.
21