Lubrication instructions
Running belt adjustment instructions
ASSEMBLY INSTRUCTIONS
A. Lubricate your running deck if it's too dry or
B. Insert the spray nozzle (B) into the spray
C. While lifting the side of the running belt, gent-
D. Repeat the above procedure on the other side
E. Then run the treadmill without anyone on it for
F. Check the running belt whether is off-center or
G. Plug in the power cord to start using the tread-
Fig.8
A. Open the Storage Door (13).
B. Allen Wrench (35) is attached on back of the
C. To adjust the belt, follow the steps on the next
Fig.9
every 6 months to maintain optimal perfor-
mance. NOTE: Lubricant is optional, please
contact your supplier to gain more infor-
mation.
head of the lubricant can (A).
ly position the spray nozzle with little drop
between the running belt and the running
deck from the front of the treadmill to the rear.
NOTE: If you lubricate too much, the run-
ning belt may slip or liquid may flow out
from the machine.
of the belt.
at least 2~3 minutes to let the lubricant spread
evenly across the running deck and underside
of the running belt.
slips - if it does, go to page 20 to center the
belt or adjust the belt tightness until the run-
ning belt has been tightened properly.
mill.
Storage Door (13).
page.
19