The Safety Key - Skandika Fitness SF-1500 Aufbau- Und Bedienungsanleitung

Repeat the above procedure until the walking belt is centered. It may be necessary to test walking
belt tension once you have completed the above procedure if the belt feels like it's slipping while
walking. Refer to the below "Walking Belt Slipping" instructions.
WALKING BELT SLIPPING: If the running belt slips when used
Fig.12

The safety key

ASSEMBLY INSTRUCTIONS
1. First remove and unplug the power cord. Using the Allen
2. Test the tightness of the belt.
3. Plug in the power cord, insert the key and walk on the
Fig.13
Wrench, turn both left and right rear roller adjustment bolts
clockwise, usually a 1/4 turn.
NOTE: NEVER TURN the bolts more then 1/4 turn at a
time and always keep the running belt centered.
NOTE: Overtightening the belt can damage the tread-
mill.
treadmill at low speed (around 2 kph/1mph) to determine if
the belt is still slipping. If the belt is still slipping, repeat the
above procedure until the walking belt has been tightened
properly.
The safety key(36) immediately disconnects the
power supply in case of an emergency, e.g. when
you fall. In order to function properly, one end of the
key should be inserted into the device (position A as
per illustration on left side) and the other end (clip
end) should be attached to your clothing (e.g. on the
waistband).
In case of an emergeny, just pull on the rope, which
will disconnect the key from the device and the de-
vice will stop immediately.
The running belt only starts moving, if the safety key
has been inserted into the device properly.
Please keep the safety key securely after your work-
out and out of reach of children!
ENGLISH
21