DeWalt D25032 Bedienungsanleitung Seite 35

6. When the screw is flush with the workpiece,
release the variable speed switch to prevent
the screw head from penetrating into the
workpiece.
Chipping and Chiselling (fig. 1)
D25033, D25133, D25134, D25143, D25144, D25263
1. Hold down the mode selector button (e)
then set the mode selector switch (d) to the
"hammering only" position.
2. Insert the appropriate chisel and rotate it by
hand to lock it into position.
3. Adjust the side handle (h) as required.
4. Switch on the tool and start working.
5. Always switch off the tool when work is finished
and before unplugging.
WARNING:
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir in flammable liquids
labelled accordingly.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
• This machine is not user-serviceable. Take the
tool to an authorised D
approximately 40 hours of use. If problems
occur before this time contact an authorised
D WALT repair agent.
e
• The tool will automatically switch off when the
carbon brushes are worn.
Motor Brushes
D WALT uses an advanced brush system which
e
automatically stops the drill when the brushes wear
out. This prevents serious damage to the motor.
New brush assemblies are available at authorised
D WALT service centers. Always use identical
e
replacement parts.
WALT repair agent after
e
Lubrication
Your power tool requires no additional lubrication.
Accessories and attachments used must be
regularly lubricated around the SDS Plus fitment.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
e
accessories should be used with this
product.
Various types of SDS Plus drill bits and chisels are
available as an option.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to
you, do not dispose of it with household waste.
Make this product available for separate collection.
english
WALT, have
e
WALT product
e
33