Viatom Checkme O2 Bedienungsanleitung Seite 7

2.4 Typical steps
START. Charge the battery. Wear
the device and the Ring Sensor,
press the button to power on. Go to
sleep.
STOP. Next morning, take off the Ring
Sensor (and
recording will be over after the
countdown.
DATA SYNC. Run App to sync data.
2.5 Start monitoring
1) Connect the sensor cable to the device.
2) Wear the device on the left wrist; wear the
sensor on the thumb. If it is too tight, try
another finger. Avoid being loose.
3) Turn on the device. After a few seconds,
the device will begin to monitor.
(If the working time is less than 1 minute,
the data will not be saved)
Note:
 The device can also work as a clock and pedometer
without ring sensor, and the steps will restart counting
after the ring sensor plugged in.
 Please avoid excessive motion for the sensed finger
during recording and avoid any strong ambient light
condition.
the device),
6
the