Programming Artromot®-S Standard; Treatment Value Details - Standard Models - DJO Global ARTROMOT-S3 Gebrauchsanleitung

Patients with
a programmed chip card
• First complete the mechanical
adjustments.
• Then insert the chip card (the patient is
not yet positioned on the CPM device).
• Press the START key: the device will
move to the starting position as speci-
fied by the parameters stored on the
chip card and stops.
• Position the patient on the CPM device
and press the START key to initiate
therapy.
. Programming
ARTROMOT®-S Standard
Di erent programming levels are provided
to program the ARTROMOT®-S Standard
models.
You change between levels by pressing the
MENU key repeatedly.
The display always indicates the currently
selected level.
The following treatment values, settings
and information can be entered/viewed
on the programming unit (1):
LEVEL :
– Abduction
– Adduction
– Internal rotation
– External rotation
LEVEL :
– Pause
– Therapy timer
– Speed
– New patient
LEVEL :
– Reverse on load - motor A
– Reverse on load - motor B
– Motor A ON/OFF
– Motor B ON/OFF
LEVEL :
– Transport setting
– Synchronized/
non-synchronized mode
– Total therapy time
– Service menu
Note!
• While you adjust the values, the
carriage will move to the set range.
This allows you to easily and quickly
determine the ROM where the pa-
tient does not experience pain.
• Special functions can be pro-
grammed and retrieved with
ARTROMOT®-S Comfort devices
(see sections 5.4 and 5.5).
• The angle entered last for the respec-
tive direction of motion will be saved
in each case.
. Treatment value details –
Standard models
• To access the programming level you
need, press the MENU key repeatedly.
• The treatment parameters are selected
with the di erent parameter keys.
• To change the treatment values, press
the + / – keys.
• To enable/disable a function, press the
respective parameter key again.
• To save the entered values, press the
STOP key.