Setting The Treatment Values - DJO Global ARTROMOT-S3 Gebrauchsanleitung

. Setting the treatment values

Warning!
Patient hazard —
Before therapy, a test run consisting
of several exercise cycles must be com-
pleted without the patient. Then repeat
the test run with the patient and check
that the movement does not cause any
pain.
Note: See also 2.2 and 2.3 as well as
page V!
Note!
Programming is only possible when the
patient's chip card has been inserted.
For information about therapy param-
eters and programming of special func-
tions, please refer to sections 5.1 to 5.5.
See section 5.6 for programming
examples.
Important!
The programming unit ARTROMOT®-S
"Graphics" can be connected to all
products of the ARTROMOT® shoulder
series with serial numbers 3000 and
higher.
It is possible to exchange chipcards
between the "Text" and "Graphics"
versions.
Please note:
1. If you use a "Graphics" programming
unit with a formatted chipcard of
the "Text" version, please note the
following
– the selected language of the"Text"
version remains activated"; it is ir-
relevant for the "Graphics" version
– the reverse on load setting saved
in the "Text" version is automati-
cally used for both motors
– the key lock is disabled.
2. If you use a "Text" programming unit
with a formatted chipcard of the
"Graphics" version, please note the
following
– the selected language automati-
cally changes to the default set-
ting: German
– the reverse on load setting saved
for motor A in the "Graphics" ver-
sion is automatically used for both
motors
– a key lock set in the "Graphics" ver-
sion will remain active, because it
is irrelevant for the "Text" version.