V-ZUG Adorina TS WP Installationsanleitung Seite 11

1
Installation
Prior to the installation, make sure that the connections
to the electric mains and to the water drain have
been properly performed (See 1.3 Connecting the
appliance to the water drain and 1.5 Connecting
the appliance to the electric mains). It this has not
been the case, have the necessary works be carried out
by a qualified electrician or technician. Have the device
be installed by an authorised customer service of your
region.
C
Preparing the place of installation, the
electrical connection, and the water drain
are the customer's responsibility.
A
Before the installation, please check the
appliance for any faults or defects. In case
of any faults or defects, the appliance must
not be installed. Damaged appliances may
be dangerous.
A
After having set up the appliance in the
customary operating position, please wait
at least 12 hours before switching it on.
1.1 The optimal place of installation
• Position your appliance on a stable, evensurface.
• The appliance is very heavy. Do not try tomove the
appliance by your own.
• Use the appliance in an well-ventilated, dust-free
environment only.
• Between the appliance and the surface beneath it,
there must not be any materials such as carpets,
woods planks or duct tape.
• Do not cover the ventilation grid of the appliance.
• The appliance's place of installation must not be near
any sliding or clap door which might hinder opening
the appliance door.
• After having completed the installation, the device
should not be moved any more. During the instal-
lation, please make sure that nothing abuts the rear
panel of the appliance (e. g. water taps, wall sockets,
or similar objects).
• Keep a minimum space of 1 cm between appliance
and furniture.
• The appliance should be operated at environment
temperatures between 5 and 35 °C only. Otherwise,
the appliance performance might suffer The rear pa-
nel of the appliance should be placed against a wall.
•
considerably and damages will occur.
B
Do not position the appliance on the
power cable.
Dryer / User Manual
1.2 Removing the transportation lock
A
Remove the transportation lock first,
before using the appliance for the first
time.
• Open the appliance door.
• Inside the drum, there is a plastic bag containing
foam material. Grab the bag at the part marked with
XX XX .
• Pull the bag out of the appliance and towards you;
in doing so you will remove the transportation lock.
A
Make sure that no transportation lock
residues remain inside the drum.
1.3 Connecting the appliance to the
water drain
For devices equipped with a condenser, as a result of
the drying process, water will aggregate in the water
tank. The water tank should
be emptied after the completion of every drying process.
Alternatively, you may drain the water directly by means
of the drainage hose (included in delivery) instead of
emptying the water tank regularly.
Connecting the drainage hose
1-2 Using your hand, pull out the hose that is attached
to the rear panel. Always use your hands only to
pull out the appliance hose. Never use any other
tools for this purpose.
3 Connect one end of the drainage hose to the spot,
from where you have just removed the hose in the
previous step.
4
Connect the other end of the water drainage hose
to the water drain (runoff) on the wall or in the
sink.
11 / 16 EN