Level Mode - Trelock LS 760 I-GO VISION Gebrauchsanweisung

LEVEL MODE

1 Switch to the highest light setting
of LS 760 I-GO® VISION.
2 Activate the Level function by
pressing the
extended time (approximately 5
seconds). You are in Level mode
when the display shows a large L.
3 Mount the light on the bracket
(see page 14).
4 Set the handlebar straight. If
there are only two bars visible on
the display, the light is tilted too
far to the left or to the right.
TOO LOW
18
+
-button for an
5 Change the horizontal orientation
of the head lamp until the ocor-
rect position has been achieved.
6 Once the setting has been made,
exit the Level function by pres-
sing the
will be exited automatically after
90 seconds.
Note: If the highest light setting can-
not be switched on due to a battery
capacity that is too low or because
the powerbank mode is active, the
Level function will not be available.
CORRECT
–
-button. The function
TOO HIGH