Transport, Storage And Disposal; Venting The Appliance - Melitta Caffeo Passione Bedienungsanleitung

Problem
Although the bean
container is full, the
appliance indicates
that coffee beans must
be filled.
Loud grinder noise.
Brewing unit cannot
be inserted after
removing.
Rapid alternate flash-
ing of the displays:
Rapid alternate flash-
ing of the displays:
The display lights up
without having been
activated:
9

Transport, storage and disposal

9.1

Venting the appliance

We recommend venting the appliance when it is not used for a long period,
prior to transport and when there is a risk of frost.
During venting, residual water is removed from the appliance.
Cause
Coffee beans do not
drop into the grinder.
Foreign objects in the
grinder.
Handle for the locking
mechanism of the
brewing unit is not in
the correct position.
Drive is not in the
correct position.
Software problem.
Brewing unit is not
inserted.
Appliance is not fully
vented.
Transport, storage and disposal
Action
Press a direct key.
ƒ
Tap lightly on the bean con-
ƒ
tainer.
Clean the bean container.
ƒ
Coffee beans are too oily. Use
ƒ
different coffee beans.
Contact the hotline.
ƒ
Check that the handle for the
ƒ
locking mechanism is correctly
engaged (see section 7.2 on
page 82).
Press and hold the "Coffee
ƒ
strength" button. Also press
the ON/OFF button. The
appliance initialises. Release
buttons again.
Switch the appliance off and
ƒ
on again (see section 4.1 on
page 64).
Contact the hotline.
ƒ
Brewing unit (inner)
ƒ
Vent the appliance, turn the
ƒ
rotary regulator clockwise
until it stops for this. As soon
as water flows out of the Cap-
puccinatore, turn the rotary
regulator anti-clockwise until
it stops.
Clean the brewing unit (see
ƒ
section 7.2 on page 82).
95