Transport, Storage And Disposal - Melitta Solo & Milk Bedienungsanleitung

Transport, Storage and
Disposal
Venting
WARNING
There is a risk of burn injuries and
scalding due to hot steam and the
hot steam pipe!
The machine releases hot steam when
it is vented.
▶ Never touch the steam pipe during
use or immediately after use.
The appliance should be vented when
it has not been used for a while or has
been transported. The appliance is then
protected from frost damage.
■ Remove the water fi lter if necessary
("Water hardness and fi lter", page 23)
and keep it cool in a glass fi lled with tap
water.
■ Switch on the device.
■ Press the
and
simultaneously for approx. 2 seconds.
fl ashes, and then
■ Pull the water tank 7 up and out of the
appliance. illuminates.
■ Place a vessel under the steam pipe 12.
■ Turn the valve switch 11 clockwise until
it stops. is fl ashing. Water fl ows out
of the steam pipe and into the vessel;
steam will also escape.
■ When there is no more steam escaping:
Turn the valve switch 11 anticlockwise
until it stops.
■ Insert the water tank into the appliance.
Operating Instructions: Melitta
Transport
■ Vent the appliance.
■ Empty and clean the drip tray and coffee
■ Empty the water tank and the bean
■ "Cleaning the brewing unit", page 25.
■ If possible, transport the appliance in
Disposal
This appliance is labelled according to
the European Directive 2002/96/EC on
waste electrical and electronic equipment
(WEEE). The Directive prescribes the
framework for a EU-wide applicable return
and recycling of waste appliances. Please
contact a specialised dealer for current
disposal procedures.
buttons
illuminates.
Solo & Milk | 1829-0618 | 2018-08
® ®

Transport, Storage and Disposal

grounds container.
container. If necessary, vacuum out
beans that are stuck at the bottom.
the original packaging including the hard
foam elements.
29