Connections, Operating And Display Elements; Operation - Cameo HYDRABEAM 1000 RGBW Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

2 3
1
POWER IN
IEC mains socket with integral fuse holder (5 x 20 mm fuse F3AL/250V). A suitable IEC power cable is included.
IMPORTANT: Replace the fuse only with a fuse of the same type and value. Follow the instructions printed on the housing. In the event of
repeated fuse failure, please contact an authorised service centre.
2
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
3
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
4 HOUSING FAN
Ensure that the fan is not obstructed and that air can circulate freely.
5
LC-DISPLAY
The illuminated LED display shows the active mode and other system information.
6
CONTROL BUTTONS
MENU – Press MENU to access the selection menu for system settings. Press repeatedly to go back to the main display.
ENTER – Press ENTER to change a value and to confirm changes.
UP and DOWN buttons – Press to move through the individual menu items in the selection menu and submenus (mode, system information,
etc.). and to change a value, such as the DMX address.
7
MIC
Microphone for music-control mode.

OPERATION

PLEASE NOTE:
As soon as the lights are correctly connected to the mains and switched on, the Cameo logo is shown in the display during the start-up and
motor reset processes. After this process, the spotlight is ready for operation and the previously selected mode will be activated.
CONFIGURE DMX START ADDRESS
Press MENU to access the selection menu for system settings. Using the UP and DOWN controls, select the menu item "DMX address"
(coloured background) and confirm with ENTER. Then a number field is displayed and you can configure the DMX start address as required
with the UP and DOWN keys (press and hold button for quick change in value, the highest value dependent on the set DMX mode). Confirm
the entry with ENTER and press MENU to return to the main display. The main display is activated automatically after approximately 1
minute of inactivity. The DMX start address is clearly visible in the middle of the display and the DMX mode is displayed on the bottom line
(03Ch, 06Ch, 09Ch, 12Ch 14Ch).
System Settings
DMX Address 001
DMX Mode CH-14
001
Auto Mode Auto06
Slave Mode Off
Advanced Settings
1 4
Operating Mode
001
499
Channel mode: 14Ch
5
7
6
5