Electrolux TK140 Benutzerinformation Seite 67

Problem
There is too much frost and
ice.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
Water flows on the floor.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' temper-
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
ENGLISH
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products
better.
Refer to "Operation" chap-
ter.
This is correct.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec-
essary.
67